National Institute Of Materials Physics - Romania

Reduced activation ferritic and martensitic steel like EUROFER (9Cr-1W) are considered as potential structural materials for the first wall of the future next-generation DEMOnstration Power Station (DEMO) fusion reactor and as a reference material for the International Thermonuclear Experimental Reactor (ITER) test blanket module. The primary motivation of this work is to study the re-deposition of the main constituent materials of EUROFER, namely tungsten (W), iron (Fe), and chromium (Cr), in a DEMO type reactor by producing and analyzing complex WxCryFe1-x-y layers. The composite layers were produced in laboratory using the thermionic vacuum arc (TVA) method, and the morphology, crystalline structure, elemental composition, and mechanical properties were studied using scanning electron microscopy (SEM), X-ray diffraction (XRD), micro-X-ray fluorescence (micro-XRF), and glow discharge optical emission spectrometry (GDOES), as well as nanoindentation and tribology measurements. The results show that the layer morphology is textured and is highly dependent on sample positioning during the deposition process. The formation of polycrystalline WxCryFe1-x-y was observed for all samples with the exception of the sample positioned closer to Fe anode during deposition. The crystalline grain size dimension varied between 10 and 20 nm. The composition and thickness of the layers were strongly influenced by the in-situ coating position, and the elemental depth profiles show a non-uniform distribution of Fe and Cr in the layers. The highest hardness was measured for the sample positioned near the Cr anode, 6.84 GPa, and the lowest was 4.84 GPa, measured for the sample positioned near the W anode. The tribology measurements showed an abrasive sliding wear behavior for most of the samples with a reduction of the friction coefficient with the increase of the normal load.

Raman investigations on nanocomposites obtained by loading various amounts of vapor grown carbon nanofibers within an isotactic polypropylene matrix, and gamma irradiated in air, at various integral doses ranging between 0 and 27 kGy, are reported. The analysis is focused on the polymer's answers as revealed by Raman spectroscopy and investigate in detail the effect of ionizing radiation on the position of the Raman line originating from the polymer. The as-obtained data are correlated to the elastic features of the nanocomposites. A competition between gamma irradiation and loading by carbon nanofiber, resulting in the stretching of the polymeric matrix and revealed as a displacement of Raman lines towards smaller wavenumber is reported. It is concluded that side groups (CH3) are less affected by the loading with carbon nanofibers,

Monolayers of transition metal (from the group VI B) dichalcogenides (MoS2, MoSe2, WS2 and WSe2) show nonvolatile resistance switching: a transition from a high to a low resistance state. Here we propose two explanations for this behaviour. The first one is that the transition metals swaps from a trigonal prismatic to an octahedral coordination (due to a high applied electric field and pressure) and thus the monolayer switches from a semiconducting to a metallic phase. The second one is a two-step process where the high electric field and pressure break the M-X bonds and the transition metal atoms become firstly tetrahedrally coordinated and afterwards square-planar coordinated. Thus, all transition metal and chalcogen atoms are in the same plane, and the transition metal atoms are in contact with the atoms of the top and bottom electrodes.

Latest developments in the field of high power ultra-short pulse lasers have led to intensive studies dedicated to the fabrication possibility of new antireflective coatings which exhibit high damage threshold. Therefore, this study is focused on the deposition and characterization of metal oxide heterostructures followed by laser-induced damage threshold tests which evidence their application in high power laser optics. Al2O3, SiO2, and HfO2 layers are combined to obtain different heterostructures, i.e. HfO2/Al2O3/HfO2/Al2O3/HfO2 and HfO2/SiO2/HfO2/SiO2/HfO2. The metal oxide heterostructures are deposited in a controllable oxygen atmosphere, either at room temperature or high temperatures (600 degrees C) by pulsed laser deposition (PLD). The morphological, structural and optical properties of the as-deposited heterostructures are first investigated. Atomic force microscopy and spectroscopic ellipsometry investigations reveal a lower roughness of the heterostructures based on HfO2/Al2O3 layers grown at 600 degrees C as compared to those grown at room temperature. Furthermore, following the laser-induced damage threshold (LIDT) tests carried out with a Ti-Sapphire laser, higher LIDT values are obtained for the HfO2/Al2O3-based heterostructures than for the HfO2/SiO2-based heterostructures. The ability to control the morphological and structural properties of the antireflective coatings by modifying the deposition parameters of the metal oxide heterostructures demonstrates that PLD is a suitable technique for the manufacturing of antireflective coatings for high power ultra-short laser systems.

Using UV-VIS absorption spectroscopy, photoluminescence (PL) and photoluminescence excitation (PLE), the photodegradation reactions of folic acid (FA) in phosphate buffer (PB) solutions were studied. Regardless of the PB solution's pH, the UV-VIS spectra showed a gradual decrease in absorbance at 284 nm simultaneous with an increase in the absorbance of another band in the spectral range of 320-380 nm, which was downshifted under UV irradiation. The relative intensity of the FA PL band, situated in the spectral range 375-600 nm, was dependent on the pH of the PB solution. The FA PL intensity increased as increasing UV irradiation time up to 281 min. in PB solutions with pH values of 6.4 and 5.4. Under an emission wavelength of 500 nm, the position of the FA PLE spectrum changed as the PB solution pH varied from 7 to 5.4 and the irradiation time increased to 317 min. These changes were correlated with the formation of two photodegradation products, namely, pterine-6-carboxylic acid and p-amino-benzoyl-L-glutamic acid. According to UV-VIS spectroscopy and PL and PLE studies, the presence of various excipients in commercial pharmaceutical tablets does not affect the photodegradation of FA in PB solutions. Using IR spectroscopy, new evidences for the formation of the two photodegradation products of FA in PB solutions are shown.

Eu3+,Tb3+-doped Sr3Al2O6 powder phosphor was synthesized via a precursor route and subjected to a subsequent thermal treatment in reducing atmosphere. Photoluminescence and thermoluminescence properties of Sr3Al2O6:Eu3+/Eu2+,Tb3+ were investigated. The structure and morphology of oxides were investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM). X-ray photoelectron spectroscopy (XPS) was used for the nanocrystals surface composition analysis. X-ray diffraction patterns confirmed the formation of the cubic structure specific to Sr3Al2O6 with space group Pa3 and lattice parameter a = 15.8322 angstrom, while SEM investigations revealed equiaxial, polycrystalline particles, with sizes in the submicronic range, for both Sr3Al2O6:Eu3+,Tb3+ and Sr3Al2O6:Eu3+/Eu2+,Tb3+ samples. The photoluminescence spectra showed the typical f-f luminescence lines of the Tb(3+ )and Eu3+ - ions, accompanied by a broad Eu2+ luminescence band at 510 nm (after calcination in reducing atmosphere). The "after-glow" luminescence signal and the thermoluminescence were assigned to the recombination of close neighbor partners (electron and Eu2+ - hole centers) within the same complex of defects.

Mixtures of nitrogen-doped titanium dioxide (TiO2:N) with different concentrations of Ag and/or SiO2 particles (0.5, 1 and 2 wt.%) were prepared in solid state by mechanico-chemical interactions. Using UV-VIS spectroscopy, Raman scattering, photoluminescence (PL) and photoluminescence excitation (PLE), the influence of the particles on the host material is evaluated. UV-VIS spectroscopy studies indicate a TiO2:N band gap shift to the UV range with increasing concentrations of SiO2 and Ag particles. PL intensities decrease with increasing concentrations of Ag and/or SiO2 particles in the TiO2:N host matrix, which in turn could effectively restrict the electron and hole recombination. To explain these processes, the different de-excitation ways will be advanced, taking into account the energy levels diagram of TiO2:N/Ag, TiO2:N/SiO2 and TiO2:N/Ag/SiO2 systems. PLE spectra show a gradual decrease in their relative intensities after 165 min of continuous irradiation due to photosensitivity of TiO2:N. The plasmonic effect of Ag particles in the TiO2:N/Ag system is highlighted for the first time by PLE studies.

In this work, we report a photodegradation process of azathioprine (AZA) highlighted by correlated studies of photoluminescence (PL) and the UV-VIS and IR absorption spectroscopy. The photodegradation process of AZA is observed by the gradual increasing in the intensity of the PL spectrum recorded under the excitation wavelength of 300 nm. This behaviour is accompanied, in the photoluminescence excitation (PLE) spectra, by a gradual intensity decreasing of the PLE band situated in the 250-320 nm spectral range simultaneous with the intensity increasing of the PLE band localized in the 325-425 nm spectral range. Regardless if the immunosuppressive compound is in the state of powder, tablet or solution, the PL and UV-VIS absorption spectroscopy studies have demonstrated that a photodegradation process under UV light takes place. According to the PL studies carried out in ambient and vacuum condition, the photodegradation process of AZA was demonstrated to be influenced by the oxygen from air. The presence of a new IR band with maximum at 1745 cm(-1) confirms the AZA photodegradation pathway proposed in this work.

Adsorption processes of 1,4-phenylene diisothiocyanate (PDITC) on two new platforms of the type graphene oxide (GO) sheets and GO layers functionalization with polydiphenylamine (PDPA) are studied by Raman scattering and photoluminescence (PL). An interaction in solid state phase of the two constituents, i.e. PDITC and GO sheets, and a deposition of PDITC onto the PDPA functionalized GO layers, respectively, by the drop casting method, were performed. In the first case, it is shown that interaction in solid state phase of GO with PDITC leads to an intercalation of the organic compound between GO sheets simultaneously with the appearance of the o-thiocarbamate groups, that induces: (i) an enhancement of the PDITC Raman lines situated in the 400-800 and 1000-1300 cm(-1) spectral ranges, (ii) a change in the ratio between the relative intensities of the two Raman lines peaked at 1585 and 1602 cm(-1) accompanied by an up-shift in the case of the second line and (iii) a down-shift of the PDTIC PL band from 502 to 491 nm. Using cyclic voltammetry, an electrochemical functionalization of the GO layers with PDPA doped with H3PMo12O40 heteropolyanions takes place, as demonstrated by Raman scattering and FTIR spectroscopy. The presence of the amine groups in the molecular structure of the doped PDPA functionalized GO layers induces a chemical adsorption of PDITC on this platform, when the thiourea groups appear simultaneously with o-thiocarbamate groups. A chemical mechanism is proposed to take place at the interface of the GO sheets and the doped PDPA functionalized GO layers, respectively, with PDITC.

The paper describes an innovative bio-design of some hybrid nanoarchitectures containing bioartificial membranes and silver nanoparticles phytogenerated by using a natural extract Caryophyllus aromaticus (cloves) that contains many bioactive compounds. Two kinds of liposomes with and without chlorophyll a (Chla) obtained through thin film hydration method were used to achieve bio-green-generated hybrids by a simple, cost effective bottom-up approach. The characteristic peaks of CE-nAg monitored by UV-Vis absorption have firstly demonstrated the biohybrids formation. The slightly blue shift and fluorescence quenching observed by fluorescence emission spectra highlighted the formation of hybrid systems by biointeraction between lipid vesicles and silver nanoparticles. The incorporation of silver nanoparticles in lipid vesicles resulted in significant changes of FT-IR spectra of liposomes, indicating a reorganization of biomimetic membranes. All the microscopic methods (SEM, AFM and TEM) confirmed the biosynthesis of "green" AgNPs together with associated biohybrids, their spherical and quasi-spherical shapes with nano-scaled size. By TEM assay it was shown that CE-nAg are surrounded by petal like cloud structures that consist of biopolymers like proteins or polysaccharides and other phytochemicals arising from clove extract. EDS spectra confirmed the formation of phyto-nanoAg and also the presence of silver in the biohybrids. In addition, Selected Area Electron Diffraction showed characteristic polycrystalline ring patterns for a cubic structure of the clove-generated AgNPs. The hybrid materials showed efficient physical stability, ie. xi value of - 28.0 mV (for biohybrids without Chla, BH) and of - 31.7 mV (for biohybrids labelled with Chla, Chla-BH), assured by strong electrostatic repulsive forces between particles. The "green" nano-silver particles (CE-nAg) showed remarkable antioxidant activity (AA = 90.2%). The biohybrids loaded with clove-AgNPs proved to be more effective, scavenging about 98.8% of free radicals (in case of ChlaBH), and of 92.6% (in case of BH). The antibacterial effectiveness showed that green AgNPs combine in a synergistic manner the antibacterial properties of clove extract with those of silver, resulting in an enhancement of inhibition diameter, by 20%. Chla-BH proved to be more potent against Escherichia coli, than BH, exhibiting an inhibition diameter of 42 mm. Regarding the in vitro cytotoxicity against tumour cells, the CE-nAg concentration significantly influenced the cell viability, ie. IC50 was 3.6% (v/v) for HT-29 cells. Chla-BH was more effective against HT-29 cancer cells at the concentrations ranging from 0 to 18% (v/v), when the normal cells were not affected. Clove-generated AgNPs exhibited haemolytic activity against hRBCs, while the biohybrids were haemocompatible. The action mechanism on the two cell lines (mouse fibroblast L929 cells and human colorectal adenocarcinoma HT-29 cells) investigated by fluorescence microscopy demonstrated that CE-nAg killed almost all the cells (94%) through necrosis at a concentration of 33.4% (v/v). The treatment of HT-29 cells with BH resulted in: 71.5% viable cells, 19.5% apoptotic and only 9% necrotic cells, while in the case of Chla-BH treatment, only 77.5% cells were viable, 16% cells were apoptotic and 6.5% were necrotic. In this way, the developed silver-based nanoparticles can represent viable promoters to develop new biohybrids with improved features, e.g. antioxidant and antibacterial effectiveness, haemolytic activity and greater specificity towards tumour cells.