National Institute Of Materials Physics - Romania

Herein, a new direct synthesis route leading to a mesoporous NiWO4 with crystalline framework and NiWO4 -graphene nanoplatelets (GNP) composite is reported. Ni and W assembled into a mesoporous tungstate type of symmetry by co-precipitation synthesis route and its composite with GNP were used as supports for electrocatalysts, with reduced Pt content (8 wt.%), in oxygen reduction reaction (ORR) and hydrogen oxidation reaction (HOR) in acidic medium. A comprehensive assessment of the modifications related to the crystalline and porous structures, morphological aspects as well as the surface chemistry aiming to explain the electrochemical properties was performed. It was found that the presence of GNP during the synthesis process leads, mainly, to the enhanced growth of NiWO4 nanocrystallites, as well as induces changes in the surface chemistry. The elec-trochemical results show that the introduction of GNPs into the NiWO4 composite support leads to a significant improvement in the activity of the Pt electrocatalyst in ORR and HOR compared to both initial NiWO4 and Pt/NiWO4 samples, as well as mechanical mixtures of these catalysts with carbon. Mass activity for hydrogen oxidation, determined in a mixed kinetic-diffusion controlled region, obtained on the 8 wt.% Pt/NiWO4-GNP catalyst was significantly higher compared to the commercial 20 wt.% Pt/C Quintech catalyst. Our comprehensive structural and surface chemistry assessments indicate this composite material as a viable electrocatalyst for PEMFCs using a broader type of fuels.& COPY; 2022 Hydrogen Energy Publications LLC. Published by Elsevier Ltd. All rights reserved.

In this study, we report the implications of the synthesis method on Gd2O3 sensitivity to CO2. The rare-earth oxide was prepared by wet chemical co-precipitation and by hydrothermal method. The obtained powders labelled Gd2O3-CoP and Gd2O3-HT were deposited as thick films over commercial Al2O3 substrates provided with Pt electrodes and a back-side heater. Both powders consist of the same crystallographic phase, with a significant difference appearing in selected area electron diffraction patterns, transmission electron microscopy images at higher magnification and X-ray diffraction spectra, with respect to the crystallization degree. The associated role in sensing properties is revealed via electrical resistance variations determined by CO2 concen-trations in the range between 400 and 3000 ppm and variable relative humidity between 0 and 50%RH, similar to the in-field atmosphere. The proposed CO2 interaction mechanism is based on phenomenological in-vestigations which highlight the electronic affinity variation as the effect of dipoles induced by the in-field conditions on the Gd2O3 surface.

Hydrogen production from methanol decomposition to syngas (H2 + CO) is a promising alternative route for clean energy transition. One major challenge is related to the quest for stable, cost-effective, and selective catalysts operating below 400 degrees C. We illustrate an investigation of the surface reactivity of a Ni3Sn4 catalyst working at 250 degrees C, by combining density functional theory, operando X-ray absorption spectroscopy, and high-resolution transmission electron microscopy. We discovered that the catalytic reaction is driven by surface tin-oxide phases, which protects the underlying Ni atoms from irreversible chemical modifications, increasing the catalyst durability. Moreover, we found that Sn content plays a key role in enhancing the H2 selectivity, with respect to secondary products such as CO2. These findings open new perspectives for the engineering of scalable and low-cost catalysts for hydrogen production.

A new approach for epitaxial stabilisation of ferroelectric orthorhombic (o-) ZrO2 films with negative piezoelectric coefficient in - 8nm thick films grown by ion-beam sputtering is demonstrated. Films on (011)-Nb: SrTiO3 gave the oriented o-phase, as confirmed by transmission electron microscopy and electron backscatter diffraction mapping, grazing incidence x-ray diffraction and Raman spectroscopy. Scanning probe microscopy techniques and macroscopic polarization-electric field hysteresis loops show ferroelectric behavior, with saturation polarization of -14.3 mu C/cm2, remnant polarization of -9.3 mu C/cm2 and coercive field -1.2 MV/cm. In contrast to the o-films grown on (011)-Nb:SrTiO3, films grown on (001)-Nb:SrTiO3 showed mixed monoclinic (m) and o-phases causing an inferior remnant polarization of -4.8 mu C/cm2, over 50% lower than the one observed for the film grown on (011)-Nb:SrTiO3. Density functional theory (DFT) calculations of the SrTiO3/ZrO2 interfaces support the experimental findings of a stable polar o-phase for growth on (011) Nb:SrTiO3, and they also explain the negative piezoelectric coefficient.

Green nanotechnology is a rapidly growing field linked to using the principles of green chemistry to design novel nanomaterials with great potential in environmental and health protection. In this work, metal and semiconducting particles (AuNPs, AgClNPs, ZnO, AuZnO, AgClZnO, and AuAgClZnO) were phytosynthesized through a "green" bottom-up approach, using burdock (Arctium lappa L.) aqueous extract. The morphological (SEM/TEM), structural (XRD, SAED), compositional (EDS), optical (UV-Vis absorption and FTIR spectroscopy), photocatalytic, and bio-properties of the prepared composites were analyzed. The particle size was determined by SEM/TEM and by DLS measurements. The phytoparticles presented high and moderate physical stability, evaluated by zeta potential measurements. The investigation of photocatalytic activity of these composites, using Rhodamine B solutions' degradation under solar light irradiation in the presence of prepared powders, showed different degradation efficiencies. Bioevaluation of the obtained composites revealed the antioxidant and antibacterial properties. The tricomponent system AuAgClZnO showed the best antioxidant activity for capturing ROS and ABTS center dot(+) radicals, and the best biocidal action against Escherichia coli, Staphylococcus aureus and Pseudomonas aeruginosa. The "green" developed composites can be considered potential adjuvants in biomedical (antioxidant or biocidal agents) or environmental (as antimicrobial agents and catalysts for degradation of water pollutants) applications.

In this study, we report on the synthesis of L-Cysteine (L-Cys)-coated magnetic iron oxide nanoparticles (NPs) loaded with doxorubicin (Dox). The Fe3O4-L-Cys-Dox NPs were extensively characterized for their compositional and morpho-structural features using EDS, SAED, XRD, FTIR and TEM. XPS, Mossbauer spectroscopy and SQUID measurements were also performed to determine the electronic and magnetic properties of the Fe3O4-L-Cys-Dox nanoparticles. Moreover, by means of a FO-SPR sensor, we evidenced and confirmed the binding of Dox to L-Cys. Biological tests on mouse (B16F10) and human (A375) metastatic melanoma cells evidenced the internalization of magnetic nanoparticles delivering Dox. Half maximum inhibitory concentration IC50 values of Fe3O4-L-Cys-Dox were determined for both cell lines: 4.26 mu g/mL for A375 and 2.74 mu g/mL for B16F10, as compared to 60.74 and 98.75 mu g/mL, respectively, for unloaded controls. Incubation of cells with Fe3O4-L-Cys-Dox modulated MAPK signaling pathway activity 3 h post-treatment and produced cell cycle arrest and increased apoptosis by 48 h. We show that within the first 2 h of incubation in physiological (pH = 7.4) media, similar to 10-15 mu M Dox/h was released from a 200 mu g/mL Fe3O4-L-Cys-Dox solution, as compared to double upon incubation in citrate solution (pH = 3), which resembles acidic environment conditions. Our results highlight the potential of Fe3O4-L-Cys-Dox NPs as efficient drug delivery vehicles in melanoma therapy.

Zeolitic imidazole frameworks (ZIFs) and TiO2 based composites have recently attracted interest to control pathogenic microorganism growth. In this context, two novel TiO2/ZIF-67 nanocomposites were synthesized by the microwave-assisted solvothermal method using two different routes: one pot composite (OPC) and two step composite (TSC) syntheses. X-ray powder diffraction and vibrational spectroscopy data revealed the formation of crystalline ZIF-67 and disordered TiO2 in the OPC composite, while both phases were crystalline in the TSC sample. Sphere-like morphologies were obtained for both materials, as indicated by SEM and TEM images. XPS measurements showed mixed-valence Ti (Ti3+/Ti4+) and Co (Co2+/Co3+) on the surface of both materials, while EPR analysis confirmed the presence of Co2+ ions and oxygen-related defects. The results showed that TiO2 has no antimicrobial activity against Staphylococcus aureus, while the TSC has higher and the OPC has lower activity than pure ZIF-67. Highly efficient biocidal activity at a concentration of 2.5 mg mL(-1) was observed for the TSC. The difference in the antimicrobial performance of the nanocomposites can be correlated with the balance between structural order/disorder, which depends on the synthesis route used, and the material solubility. The results also indicate the release of Co ions and the ligand as a possible mechanism together with redox reactions to inactivate bacteria. Thus, this work provides simple and promising synthesis routes to obtain TiO2/ZIF-67 nanocomposites for potential use as new antimicrobial agents.

The aim of this paper is to provide a simple and efficient photoassisted approach to synthesize silver nanoparticles, and to elucidate the role of the key factors (synthesis parameters, such as the concentration of TSC, irradiation time, and UV intensity) that play a major role in the photochemical synthesis of silver nanoparticles using TSC, both as a reducing and stabilizing agent. Concomitantly, we aim to provide an easy way to evaluate the particle size based on Mie theory. One of the key advantages of this method is that the synthesis can be "activated" whenever or wherever silver nanoparticles are needed, by premixing the reactants and irradiating the final solution with UV radiation. UV irradiance was determined by using Keitz's theory. This argument has been verified by premixing the reagents and deposited them in an enclosed space (away from sunlight) at 25 degrees C, then checking them for three days. Nothing happened, unless the sample was directly irradiated by UV light. Further, obtained materials were monitored for 390 days and characterized using scanning electron microscopy, UV-VIS, and transmission electron microscopy.

In this work, Tungsten(W)-doped TiO2 nanoparticles were synthesized using the sol-gel method and were used as electrode materials in supercapacitor applications. The structural and morphological properties of the prepared samples were analyzed by means of XRD, STEM, TEM, and XPS. The analysis of the defect centers was carried out using EPR spectroscopy. The electrochemical analysis of the assembled supercapacitor was done using cyclic voltammetry, galvanostatic cycling with potential limitation technique, potentiostatic electrochemical impedance spectroscopy, and voltage-holding experiments. All the presented samples showed paramagnetic defects in the EPR analysis, while 0.5% W-doped TiO2 showed a maximum signal intensity. The supercapacitor performance from the synthesized electrode material showed highly encouraging results. The equivalent series resistance (R-s) value for all the designs showed values under "1 omega,' which reflects high conductivity. As the maximum EPR intensity comes from TiO2 doped with 0.5% W, the supercapacitor performance of this sample was tested with a newly designed five-electrode system. This design showed superior performance compared to any other used designs with a specific capacitance of 25.5 F g(-1), with an energy density of 14.16 Wh kg (-1 )at 302 kW kg (-1).

Glassy nanocomposites containing Yb3+/Er3+-doped GdF3 and LiGdF4 nanocrystals have been prepared by controlled crystallization of the xerogel and the structural, up-conversion luminescence, and magnetic properties were analyzed and discussed. Structural and morphological analysis showed uniform distribution of both GdF3 and LiGdF4 nanocrystals (tens of nm size), embedded in silica glass matrix as the result of thermal decomposition of the trifluoracetates, revealed as a strong exothermic peak at about 300 degrees C; the Li-ions co-doping showed a strong influence on the GdF3 and LiGdF4 nanocrystalline fraction. The energy dispersive spectrometry mapping showed Gd, F and Yb, Er within the nanocrystals but not in the silica glass matrix. X-ray diffraction pattern analysis indicated the crystalline lattice distortion consistent with the Yb/Er incorporation in both fluoride nanocrystals. The "green" ((H-2(11/2), S-4(3/2)) -> I-4(15/2)) and "red" (F-4(9/2)-> I-4(15/2)) up-conversion luminescences at 525, 545, and 660 nm observed under 980 nm laser light pumping were assigned to the Er3+ ions deexcitation through a two-photon process. The magnetic properties of the nanocomposite are strongly temperature dependent. The magnetization hysteresis loops show a ferromagnetic behavior at low temperatures (5K) related to the rare-earth ions contribution and the saturation magnetization of 39 emu/g. At 300 K a paramagnetic behavior was observed that was ascribed to the non-interacting localized nature of the magnetic moment of the rare-earth ions. Hence, such novel, multifunctional magnetic and optical materials can allow the intertwining between magnetism and photonics and might offer new opportunities for new magneto-optical device development.