National Institute Of Materials Physics - Romania

Trilayer memory capacitors of control HfO2/floating gate of Ge nanoparticles in HfO2/tunnel HfO2/Si substrate deposited by magnetron sputtering and subsequently annealed are investigated for the first time for applications in radiation dosimetry. In the floating gate (FG), amorphous Ge nanoparticles (NPs) are arranged in two rows inside the HfO2 matrix. The HfO2 matrix is formed of orthorhombic/tetragonal nanocrystals (NCs). The adjacent thin films to the FG are also formed of orthorhombic/tetragonal HfO2 NCs. This phase is formed during annealing, in samples with thick control HfO2, in the presence of Ge, being induced by the stress. In the rest of the control oxide, HfO2 NCs are monoclinic. Orthorhombic HfO2 has ferroelectric properties and therefore enhances the memory window produced by charge storage in Ge NPs to above 6 V. The high sensitivity of 0.8 mV Gy(-1) to a particle irradiation from a Am-241 source was measured by monitoring the flatband potential during radiation exposure after electrical writing of the memory.

Artificial complex-oxide heterostructures containing ultrathin buried layers grown along the pseudocubic [111] direction have been predicted to host a plethora of exotic quantum states arising from the graphene-like lattice geometry and the interplay between strong electronic correlations and band topology. To date, however, electronic-structural investigations of such atomic layers remain an immense challenge due to the shortcomings of conventional surface-sensitive probes with typical information depths of a few angstroms. Here, we use a combination of bulk-sensitive soft X-ray angle-resolved photoelectron spectroscopy (SX-ARPES), hard X-ray photoelectron spectroscopy (HAXPES), and state-of-the-art first-principles calculations to demonstrate a direct and robust method for extracting momentum-resolved and angle-integrated valence-band electronic structure of an ultrathin buckled graphene-like layer of NdNiO3 confined between two 4-unit cell-thick layers of insulating LaAlO3. The momentum-resolved dispersion of the buried Ni d states near the Fermi level obtained via SX-ARPES is in excellent agreement with the first-principles calculations and establishes the realization of an antiferro-orbital order in this artificial lattice. The HAXPES measurements reveal the presence of a valence-band bandgap of 265 meV. Our findings open a promising avenue for designing and investigating quantum states of matter with exotic order and topology in a few buried layers.

As a new class of sustainable carbon material, "carbon dots" is an umbrella term covering many types of materials. Herein, a broad range of techniques was used to develop the understanding of hydrothermally synthesized carbon dots, and it is shown how fine-tuning the structural features by simple reduction/oxidation reactions can drastically affect their excited-state properties. Structural and spectroscopic studies found that photoluminescence originates from direct excitation of localized fluorophores involving oxygen functional groups, whereas excitation at graphene-like features leads to ultrafast phonon-assisted relaxation and largely quenches the fluorescent quantum yields. This is arguably the first study to identify the dynamics of photoluminescence including Stokes shift and allow the relaxation pathways in these carbon dots to be fully resolved. This comprehensive investigation sheds light on how understanding the excited-state relaxation processes in different carbon structures is crucial for tuning the optical properties for any potential commercial applications.

Electronic phase separation is crucial for the fascinating macroscopic properties of the LaAlO3/SrTiO3 (LAO/STO) paradigm oxide interface, including the coexistence of superconductivity and ferromagnetism. We investigate this phenomenon using angle-resolved photoelectron spectroscopy (ARPES) in the soft-x-ray energy range, where the enhanced probing depth combined with resonant photoexcitation allow us access to fundamental electronic structure characteristics - momentum-resolved spectral function, dispersions and ordering of energy bands, Fermi surface - of buried interfaces. Our experiment uses x-ray irradiation of the LAO/STO interface to tune its oxygen deficiency, building up a dichotomic system where mobile weakly correlated Ti t(2g) electrons coexist with localized strongly correlated Ti e(g) ones. The ARPES spectra dynamics under x-ray irradiation shows a gradual intensity increase under constant Luttinger count of the Fermi surface. This fact identifies electronic phase separation (EPS) where the mobile electrons accumulate in conducting puddles with fixed electronic structure embedded in an insulating host phase, and allows us to estimate the lateral fraction of these puddles. We discuss the physics of EPS invoking a theoretical picture of oxygen-vacancy clustering, promoted by the magnetism of the localized Ti e(g) electrons, and repelling of the mobile t(2g) electrons from these clusters. Our results on the irradiation-tuned EPS elucidate the intrinsic one taking place at the stoichiometric LAO/STO interfaces.

Angle-resolved photoelectron spectroscopy (ARPES) is the main experimental tool to explore electronic structure of solids resolved in the electron momentum k. Soft-X-ray ARPES (SX-ARPES), operating in a photon energy range around 1 keV, benefits from enhanced probing depth compared to the conventional VUV-range ARPES, and elemental/chemical state specificity achieved with resonant photoemission. These advantages make SX-ARPES ideally suited for buried heterostructure and impurity systems, which are at the heart of current and future electronics. These applications are illustrated here with a few pioneering results, including buried quantum-well states in semiconductor and oxide heterostructures, their bosonic coupling critically affecting electron transport, magnetic impurities in diluted magnetic semiconductors and topological materials, etc. High photon flux and detection efficiency are crucial for pushing the SX-ARPES experiment to these most photon-hungry cases.

Eu3+,Tb3+-doped Sr3Al2O6 powder phosphor was synthesized via a precursor route and subjected to a subsequent thermal treatment in reducing atmosphere. Photoluminescence and thermoluminescence properties of Sr3Al2O6:Eu3+/Eu2+,Tb3+ were investigated. The structure and morphology of oxides were investigated by X-ray diffraction (XRD) and scanning electron microscopy (SEM). X-ray photoelectron spectroscopy (XPS) was used for the nanocrystals surface composition analysis. X-ray diffraction patterns confirmed the formation of the cubic structure specific to Sr3Al2O6 with space group Pa3 and lattice parameter a = 15.8322 angstrom, while SEM investigations revealed equiaxial, polycrystalline particles, with sizes in the submicronic range, for both Sr3Al2O6:Eu3+,Tb3+ and Sr3Al2O6:Eu3+/Eu2+,Tb3+ samples. The photoluminescence spectra showed the typical f-f luminescence lines of the Tb(3+ )and Eu3+ - ions, accompanied by a broad Eu2+ luminescence band at 510 nm (after calcination in reducing atmosphere). The "after-glow" luminescence signal and the thermoluminescence were assigned to the recombination of close neighbor partners (electron and Eu2+ - hole centers) within the same complex of defects.

A series of five Cu(x)CeMgAlO mixed oxides with different copper contents (x) ranging from 6 to 18 at. % with respect to cations, but with fixed 10 at. % Ce and Mg/Al atomic ratio of 3, were prepared by thermal decomposition of layered double hydroxide (LDH) precursors at 750 degrees C. The solid containing 15 at. % Cu, i.e. Cu (15)CeMgAlO, was also calcined at 550 and 650 degrees C. Powder XRD was used to characterize the crystalline structure and SEM-EDX was used to monitor the morphology and chemical composition of both as prepared and calcined materials. Additionally, the textural properties and the reducibility of the mixed oxide catalysts were studied by nitrogen adsorption/desorption and temperature programmed reduction with hydrogen (H-2-TPR) techniques, respectively. X-ray photoelectron spectroscopy (XPS) was used to determine the chemical state of the elements on the catalyst surface and the diffuse reflectance UV-vis spectroscopy, to obtain information about the stereochemistry and aggregation of copper in the Cu-containing mixed oxides. Their catalytic properties in the total oxidation of methane, used as a volatile organic compound (VOC) model molecule, were evaluated and compared with those of an industrial Pd/Al2O3 catalyst. Their catalytic behavior was explained in correlation with their physicochemical properties. Cu(15)CeMgAlO mixed oxide was shown to be the most active catalyst in this series, with a T-50 (temperature corresponding to 50% methane conversion) value of only ca. 45 degrees C higher than that of a commercial Pd/Al2O3 catalyst. This difference becomes as low as ca. 25 degrees C for the Cu(15)CeMgAlO system calcined at 550 degrees C. The influences of the contact time and of the methane concentration in the feed gas on the catalytic performances of the Cu(15)CeMgAlO catalyst have been investigated and its good stability on stream was evidenced.

Mixtures of nitrogen-doped titanium dioxide (TiO2:N) with different concentrations of Ag and/or SiO2 particles (0.5, 1 and 2 wt.%) were prepared in solid state by mechanico-chemical interactions. Using UV-VIS spectroscopy, Raman scattering, photoluminescence (PL) and photoluminescence excitation (PLE), the influence of the particles on the host material is evaluated. UV-VIS spectroscopy studies indicate a TiO2:N band gap shift to the UV range with increasing concentrations of SiO2 and Ag particles. PL intensities decrease with increasing concentrations of Ag and/or SiO2 particles in the TiO2:N host matrix, which in turn could effectively restrict the electron and hole recombination. To explain these processes, the different de-excitation ways will be advanced, taking into account the energy levels diagram of TiO2:N/Ag, TiO2:N/SiO2 and TiO2:N/Ag/SiO2 systems. PLE spectra show a gradual decrease in their relative intensities after 165 min of continuous irradiation due to photosensitivity of TiO2:N. The plasmonic effect of Ag particles in the TiO2:N/Ag system is highlighted for the first time by PLE studies.

Control of structural coupling at complex-oxide interfaces is a powerful platform for creating ultrathin layers with electronic and magnetic properties unattainable in the bulk. However, with the capability to design and control the electronic structure of such buried layers and interfaces at a unit-cell level, a new challenge emerges to be able to probe these engineered emergent phenomena with depth-dependent atomic resolution as well as element- and orbital selectivity. Here, we utilize a combination of core-level and valence-band soft x-ray standing-wave photoemission spectroscopy, in conjunction with scanning transmission electron microscopy, to probe the depth-dependent and single-unit-cell resolved electronic structure of an isovalent manganite superlattice [Eu0.7Sr0.3MnO3/La0.7Sr0.3MnO3] x 15 wherein the electronic-structural properties are intentionally modulated with depth via engineered oxygen octahedra rotations/tilts and A-site displacements. Our unit-cell resolved measurements reveal significant transformations in the local chemical and electronic valence-band states, which are consistent with the layer-resolved first-principles theoretical calculations, thus opening the door for future depth-resolved studies of a wide variety of heteroengineered material systems.

The present investigation deals with the development, characterization and application of nano-structured Pd doped Ni electrodes (Pd@Ni), which uses the electrochemical properties of Pd in synergy with the magnetic properties of Ni for biosensors development. The Pd@Ni electrodes have been characterized by X-ray diffraction, scanning electron microscopy with energy dispersive X-ray spectroscopy and X-ray photoelectron spectroscopy. It has been shown that palladium presented spherical assemblies ranging 150-200 nm medium diameter size that covers large areas of the electrode surface while metallic nickel, which confers magnetic properties, showed a uniform granular structure with sizes between 20 and 50 nm. Cyclic voltammetry and electrochemical impedance spectroscopy were performed to understand the electrochemical process at the Pd@Ni electrodes in neutral media. The Pd@Ni electrodes were applied for the electrochemical detection of H2O2. Finally, Ni nanoparticles (NiNP) functionalized with the model enzyme glucose oxidase (GOx-NiNP) have been attached to the Pd@Ni electrode solely through magnetic interactions, and the obtained GOx-NiNP/Pd@Ni biosensor applied for glucose determination in aqueous solutions by fixed potential amperometry at -0.05 V (vs Ag/AgCl) with reduced interferences. (C) 2019 Elsevier Ltd. All rights reserved.