Publications

Characterization of (Fe1-xNix)3C and (Fe1-xCOx)3C identified in metallic inclusions in synthetic diamond crystals grown in Fe-Ni-C and Fe-Co-C systems at a pressure of approximately 5.5 GPa and a temperature of approximately 1800 K was carried out using X-ray microprobe analysis, X-ray diffraction, hardness data, Mossbauer and magnetic measurements. The result suggests that in (Fe1-xCox)3C, metallic atoms have an electronic structure similar to that of Co.

The use of IR spectroscopic method to choose the best batches of ZSM-5 zeolites. is discussed. The crystallinity and the particle size were estimated from IR spectra and by XRD and electron microscopy measurements.

An analysis of the permitted structures for a cholesteric liquid crystal based on the continuum theory as a function of the anchoring conditions and the thickness of the liquid crystal layer is presented. A new type of bistability is found. The stability domains of various structure types are given.

In quasi-homeotropic oriented liquid crystal cells, obtained by oblique SiO deposition on glass and surfactant added to the nematic, a continuous tilt angle versus temperature change followed by an abrupt surface transition was observed. At room temperature, the sip of the tilt angle measured from the normal to the surface depends on the SiO deposition angle. A model for the temperature dependence of the tilt angle is proposed.

A new method for producing tilt angle in liquid crystal cells is proposed. The method requires a SiO vacuum deposition layer which is subsequently covered with a polyvinyl alcohol (PVA) layer, obtained by dipping in a solution. It was possible to obtain tilt angles between 7 and 30-degrees by changing the concentration of PVA in the solution.

We prepared superconducting Bi1.6Pb0.4-xBxSr2Ca2CU3Oy (x=0, 0.1, 0.2, 0.3 and 0.4) ceramics by the melt-quenching method and examined the effect of B addition on the formation of the high-Tc phase.The temperatures and sequence of formation of the superconducting phases within this composition were determined using simultaneous differential thermal analysis (DTA) and thermogravimetric analysis (TGA), X- ray powder diffraction (XRD). It was found that the bulk ceramics with x=0.1 and 0.2 exhibited superconductivity with a critical temperature range of 95-100 K. The lowering of the partial melting temperature caused by the coexistence of Pb and B elements is effective for the formation mechanism of the high-Tc phase.

The effect of thermal treatment and sweeping at different temperatures on the current peaks occurring during the heating-up phase of the electrodiffusion runs are studied. Arrhenius plots of swept synthetic quartz are discussed.

The paper outlines conditions under which the statistical shift of the Fermi level within the density-of-states (DOS) distribution may result in the Meyer-Neldel correlation. Sufficient conditions have been found: (i) The DOS should have, around the Fermi level, two competing exponential slopes; (ii) The temperature range for the statistical shift should correspond to kT values higher than at least one of these two characteristic energies associated with the slopes. Under such conditions, the Fermi level is no longer the dominant energy for carrier-concentration changes. Relating the Mayer-Neldel correlation to DOS parameters is an essential step in a correct deduction of Mott's minimum-metallic-conductivity value from experiment.