National Institute Of Materials Physics - Romania

The current study was focused on the potential of pure P25 TiO2 nanoparticles (NPs) and Fe(1%)-N co-doped P25 TiO2 NPs to induce cyto- and genotoxic effects in MRC-5 human pulmonary fibroblasts. The oxidative lesions of P25 NPs were reflected in the amount of 8-hydroxydeoxyguanosine accumulated in DNA and the lysosomal damage produced, but iron-doping partially suppressed these effects. However, neither P25 nor Fe(1%)-N co-doped P25 NPs had such a serious effect of inducing DNA fragmentation or activating apoptosis signaling. Moreover, oxo-guanine glycosylase 1/2, a key enzyme of the base excision repair mechanism, was overexpressed in response to the oxidative DNA deterioration induced by P25 and P25-Fe(1%)-N NPs.

Sub-stochiometric nickel oxide (NiOx) films were investigated as a hole selective contact option in silicon (Si) heterojunction solar cells. Numerical simulations were carried out to evaluate the impacts of the NiOx electronic properties variations and the NiOx/Si interface defect density (D-it) on device performance. Simulation data suggest that the best performance is achievable for wide bandgaps (E-g) and corresponding high valence band edge (E-VB) positions in the NiOx films. Overall, in simulations, the performance remains practically unchanged for the nickel vacancy concentrations [V-Ni] = 10(17)-10(21 )cm(-3), assuming high E-VB and low D-it. The experimental data measured using NiOx films prepared by radio-frequency magnetron sputtering reveal that the increase in [V-Ni] lifts the conductivity, concurrently decreasing E-g and E-VB. As a result, we concluded that the performance of the fabricated sputtered NiOx/Si heterojunction solar cell is limited by high D-it as well as narrow E-g and low E-VB.

Using the microwave-assisted sol-gel method, Zn- and Cu-doped TiO2 nanoparticles with an anatase crystalline structure were prepared. Titanium (IV) butoxide was used as a TiO2 precursor, with parental alcohol as a solvent and ammonia water as a catalyst. Based on the TG/DTA results, the powders were thermally treated at 500 degrees C. XRD and XRF revealed the presence of a single-phase anatase and dopants in the thermally treated nanoparticles. The surface of the nanoparticles and the oxidation states of the elements were studied using XPS, which confirmed the presence of Ti, O, Zn, and Cu. The photocatalytic activity of the doped TiO2 nanopowders was tested for the degradation of methyl-orange (MO) dye. The results indicate that Cu doping increases the photoactivity of TiO2 in the visible-light range by narrowing the band-gap energy.

Due to the emergence of antibiotic-resistant pathogens, the need to find new, efficient antimicrobial agents is rapidly increasing. Therefore, in this study, we report the development of new biocomposites based on zinc-doped hydroxyapatite/chitosan enriched with essential oil of Artemisia dracunculus L. with good antimicrobial activity. Techniques such as scanning electron microscopy (SEM), X-ray diffraction (XRD), energy dispersive X-ray spectroscopy (EDX) and Fourier transform infrared spectroscopy (FTIR) were used in order to evaluate their physico-chemical properties. Our studies revealed that biocomposite materials with nanometric dimension and homogeneous composition could be obtained through an economic and cost-effective synthesis method. The biological assays demonstrated that ZnHA (zinc-doped hydroxyapatite), ZnHACh (zinc-doped hydroxyapatite/chitosan) and ZnHAChT (zinc-doped hydroxyapatite/chitosan enriched with essential oil of Artemisia dracunculus L.) did not exhibit a toxic effect on the cell viability and proliferation of the primary osteoblast culture (hFOB 1.19). Moreover, the cytotoxic assay also highlighted that the cell morphology of the hFOB 1.19 was not altered in the presence of ZnHA, ZnHACh or ZnHAChT. Furthermore, the in vitro antimicrobial studies emphasized that the samples exhibited strong antimicrobial properties against Escherichia coli ATCC 25922, Staphylococcus aureus ATCC 25923 and Candida albicans ATCC 10231 microbial strains. These results are encouraging for the following development of new composite materials with enhanced biological properties that could promote the osteogenic process of bone healing and also exhibit good antimicrobial properties.

Sodium hexatitanate (Na2Ti6O13) nanoparticles have been synthesized by the hydrothermal method with microwave and conven-tional heating, after which their photocatalytic properties toward an azo dye pollutant degradation have been investigated. Insights into the dynamics and reactivity of the species involved in the photocatalytic mechanism of the (Na2Ti6O13) samples were precisely investigated, for the first time, by X-band electron paramagnetic resonance (EPR) spectroscopy under different experimental conditions. X-ray diffraction structural analysis revealed that all samples crystallized in a monoclinic C2/m structure, with different short-range structural order according to the employed heating, as indicated by Raman. Field-emission scanning electron microscopy and transmission electron microscopy results revealed the formation of rod-and fiber-like nanoparticles with different diameters and lengths. EPR measurements indicated the presence of different Ti3+ point defects and F centers in the samples. X-ray photoelectron spectroscopy analysis proved the presence of oxygen-related defects, but no Ti3+ was detected on the surface. Spin trapping experiments monitored the generation of hydroxyl (OH center dot) radicals over UV-irradiation time. Various parameters contribute to the photocatalytic activity of the samples; however, the type of defect and particle morphology appeared as key factors for enhanced efficiency. Our study provides significant information about paramagnetic defects in Na2Ti6O13 materials and their role in photocatalysis to design other Ti-based photocatalysts.

Nonmagnetic chiral crystals are a new class of systems hosting Kramers-Weyl Fermions, arising from the combination of structural chirality, spin- orbit coupling (SOC), and time-reversal symmetry. These materials exhibit nontrivial Fermi surfaces with SOC-induced Chern gaps over a wide energy range, leading to exotic transport and optical properties. In this study, we investigate the electronic structure and transport properties of CdAs2, a newly reported chiral material. We use synchrotron-based angle-resolved photoelectron spectroscopy (ARPES) and density functional theory (DFT) to determine the Fermiology of the (110)-terminated CdAs2 crystal. Our results, together with complementary magnetotransport measurements, suggest that CdAs2 is a promising candidate for novel topological properties protected by the structural chirality of the system. Our work sheds light on the details of the Fermi surface and topology for this chiral quantum material, providing useful information for engineering novel spintronic and optical devices based on quantized chiral charges, negative longitudinal magnetoresistance, and nontrivial Chern numbers.

The development of new thin-film cathodes triggered a recent research interest in energy storage applications. Over the past years, vanadium oxides have been extensively explored as promising electrodes for batteries owing to their rich valence states and remarkable electrochemical properties. Herein, we report on the synthe-sis of undoped and Sn doped V2O3 thin-films on graphene (G)/Al foil by pulsed laser deposition followed by rapid thermal annealing in N2 at low temperature (similar to 430 degrees C). The obtaining V2O3 phase on graphene/Al foil (G/Al) has been confirmed by X-ray diffraction and Raman and X-ray photoelectron spectroscopy analyses. The synthesized vanadium oxide films were tested as cathodes in coin cells. The electrochemical properties have been systematically investigated by cyclic voltammetry (CV), electrochemical impedance spectroscopy (EIS), and galvanostatic charge discharge (GCD) measurements. A superior electrochemical performance was observed for the V2O3 on G/Al structures, with an initial capacity of around 300 mAh g-1, with respect to the bare G/Al electrode. The use of the Sn-doped (5 mol%) V2O3 thin-films improved slightly the initial capac-ity up to a value of ca. 311 mAh g-1. Both V2O3/G/Al and Sn-doped V2O3/G/Al exhibited excellent cycling performances after 40 cycles with a capacity maintenance at a C-rate C/20 of 317 mAh g-1. Long-term cycling test (up to 200 cycles) showed that the Sn doping could be an excellent strategy to improve the stability of the electrodes, which yielded a capacity loss of only 0.128% per cycle. Possible mechanisms are presented and dis-cussed. This work could serve as point of reference for future developments in the field of batteries employing vanadium oxide-based thin-films deposited by physical vapor deposition techniques.

In the quest for novel rare earth (RE)-free magnetic materials, which also exhibit other additional properties such as good corrosion resistance and potential to operate at higher temperatures, an alloy deriving from the binary FePt system, with Mo and B addition, has been synthesized for the first time, using the out-of-equilibrium method of rapid solidification form the melt. The alloy with the composition Fe49Pt26Mo2B23 has been subjected to thermal analysis through differential scanning calorimetry in order to detect the structural disorder - order phase transformation as well as to study the crystallization processes. For the stabilization of the formed hard magnetic phase, the sample has been annealed at 600 degrees C and further structurally and magnetically characterized by means of X-ray diffraction, transmission electron microscopy, Fe-57 Mossbauer spectrometry as well as magnetometry experiments. It has been proven that after annealing at 600 degrees C the tetragonal hard magnetic L1(0) phase emerges via crystallization from a disordered cubic precursor and becomes the predominant phase in terms of relative abundance. Moreover, it has been revealed by quantitative analysis via Mossbauer spectroscopy that the annealed sample exhibits a complex phase structure, where the L1(0) hard magnetic phase is accompanied by few other soft magnetic phases, in minority abundance: the cubic A1, orthorhombic Fe2B and residual intergranular region. The magnetic parameters have been derived from 300 K hysteresis loops. It was shown that, contrary to the as-cast sample which behaves as a typical soft magnet, the annealed sample presents strong coercivity and high remanent magnetization, accompanied by a large saturation magnetization. These findings offers good insight into the potential developing of novel class of RE-free permanent magnets, based on Fe-Pt-Mo-B, where the magnetic performance emerges from the co-existence of hard and soft magnetic phases in controlled and tunable proportions, capable of finding good applicability in fields requiring good catalytic properties and strong corrosion resistance.

Transparent conductive electrodes (TCE) obtained by the electrospinning method and gold covered were used as cathodes in the organic light-emitting diodes (OLEDs) to create double side-emission. The electro-active nanofibers of poly(methyl methacrylate) (PMMA) with diameters in the range of several hundreds of nanometers, were prepared through the electrospinning method. The nanofibers were coated with gold by sputtering deposition, maintaining optimal transparency and conductivity to increase the electroluminescence on both electrodes. Optical, structural, and electrical measurements of the as-prepared transparent electrodes have shown good transparency and higher electrical conductivity. In this study, two types of OLEDs consisting of indium tin oxide (ITO)/ poly(3,4-ethylenedioxythiophene) polystyrene sulfonate (PEDOT-PSS)/ Ir(III) complex (8-hydroxyquinolinat bis(2-phenylpyridyl) iridium-IrQ(ppy)(2) 20 wt% embedded in N, N '-Dicarbazolyl-4,4 '-biphenyl (CBP) sandwich structure and either gold-covered PMMA electrospun nanoweb (OLED with electrospun cathode) were fabricated together with a similar structure containing thin film gold cathodes (OLED with thin film cathode). The luminance-current-voltage characteristics, the capacitance-voltage, and the electroluminescence properties of these OLEDs were investigated.

In the quest for novel rare earth (RE)-free magnetic materials, which also exhibit other additional properties such as good corrosion resistance and potential to operate at higher temperatures, an alloy deriving from the binary FePt system, with Mo and B addition, has been synthesized for the first time, using the out-of-equilibrium method of rapid solidification form the melt. The alloy with the composition Fe49Pt26Mo2B23 has been subjected to thermal analysis through differential scanning calorimetry in order to detect the structural disorder - order phase transformation as well as to study the crystallization processes. For the stabilization of the formed hard magnetic phase, the sample has been annealed at 600 degrees C and further structurally and magnetically characterized by means of X-ray diffraction, transmission electron microscopy, Fe-57 Mossbauer spectrometry as well as magnetometry experiments. It has been proven that after annealing at 600 degrees C the tetragonal hard magnetic L1(0) phase emerges via crystallization from a disordered cubic precursor and becomes the predominant phase in terms of relative abundance. Moreover, it has been revealed by quantitative analysis via Mossbauer spectroscopy that the annealed sample exhibits a complex phase structure, where the L1(0) hard magnetic phase is accompanied by few other soft magnetic phases, in minority abundance: the cubic A1, orthorhombic Fe2B and residual intergranular region. The magnetic parameters have been derived from 300 K hysteresis loops. It was shown that, contrary to the as-cast sample which behaves as a typical soft magnet, the annealed sample presents strong coercivity and high remanent magnetization, accompanied by a large saturation magnetization. These findings offers good insight into the potential developing of novel class of RE-free permanent magnets, based on Fe-Pt-Mo-B, where the magnetic performance emerges from the co-existence of hard and soft magnetic phases in controlled and tunable proportions, capable of finding good applicability in fields requiring good catalytic properties and strong corrosion resistance.