National Institute Of Materials Physics - Romania

Single-doped [Ag, Na, iodine, naphthalene (Naph), meta-dintrobenzene (m-DNB)] and double-doped, organic-inorganic (Naph + iodine; m-DNB + iodine) benzil (Bz) crystals have been grown from melt in a Bridgman-Stockbarger configuration. All crystals have been grown in the same experimental conditions, temperature variation at the growth interface = 30 K and moving speed of the growth ampoule = 1 mm/h. These conditions have been estimated from the theoretical analysis involving the solution of the classical (conventional) Stefan problem for flat solid-liquid interface in the boundary conditions imposed by our growth system. The effect of doping on the disorder degree, photoluminescence and dielectric constant of the Bz matrix has been investigated. The disorder in the crystals increased with the increase of dopant concentration. The highest disorder was induced by the organic dopant m-DNB, whose molecules does not show an adequate geometrical similarity with Bz molecules. The position of the photoluminescence peak, both at excitation with 335 nm and 435 nm, has not been affected by the presence of dopant(s). All doped samples show Second Harmonic Generation, even those with a significant degree of disorder. The effect of the single and double-doping on the second-order ONL co-efficient was analyzed by comparison with the second-order ONL coefficient of pure Bz crystals. In the case of the double-doping, the highest second-order optical nonlinear coefficient has been evidenced in the Bz crystals simultaneously doped with m-DNB and iodine in the same concentration (1%).

We formulate a general criterion that underlies the persistence of conductance zeros induced by destructive quantum interference under the application of external perturbations in physical systems described by a discrete nonsingular Hamiltonian H. Our approach uses nonzero matrix elements of H???1 between two lattice points as edges of a graph to indicate the existence of a nonzero conductance between the same points. A given conductance zero, or a missing edge in the inverted graph, is preserved when the perturbation, in the form of on-site or additional interpoint hopping energies, is applied only to points outside the set of first-order graph neighbors of either the entry lead or the exit lead. We discuss the application of these results to a study of the robustness of the conductance zeros in the fulvene and benzene molecules.

We present theoretical calculations for the cyclotron resonance and various magnetoplasmon modes of a Coulomb interacting two-dimensional GaAs electron gas (2DEG) modulated as a lateral superlattice of quantum dots subjected to an external perpendicular constant magnetic field. We use a real-time excitation approach based on the Liouville???von Neumann equation for the density operator, that can go beyond linear response delivering information of all longitudinal and transverse collective modes of interest to the same order. We perform an extensive analysis of the coexisting collective modes due to the lateral confinement and the magnetic field for a different number of electrons in each dot. In the limit of vanishing dot modulation of the 2DEG we find signs of the structure of the Hofstadter butterfly in the excitation spectra.

A new core-shell pH-responsive nanocarrier was prepared based on magnetic nanoparticle (MNP) core. Magnetic nanoparticles were first modified with hyperbranched polyglycerol as the first shell. Then the magnetic core was decorated with doxorubicin anticancer drug (DOX) and covered with PEGylated carboxymethylcellulose as the second shell. Borax was used to partially cross-link organic shells in order to evaluate drug loading content and pH-sensitivity. The structure of nanocarrier, organic shell loadings, magnetic responsibility, morphology, size, dispersibility, and drug loading content were investigated by IR, NMR, TG, VSM, XRD, DLS, HR-TEM and UV-Vis analyses. In vitro release investigations demonstrated that the use of borax as cross-linker between organic shells make the nanocarrier highly sensitive to pH so that more that 70% of DOX is released in acidic pH. A reverse pH sensitivity was observed for the nanocarrier without borax cross-linker. The MTT assay determined that the nanocarrier exhibited excellent biocompatibility toward normal cells (HEK-293) and high toxicity against cancerous cells (HeLa). The nanocarrier also showed high hemocompatibility. Cellular uptake revealed high ability of nanocarrier toward HeLa cells comparable with free DOX. The results also suggested that low concentration of nanocarrier has a great potential for use as contrast agent in magnetic resonance imaging (MRI).

The use of superconducting (SC) materials is crucial for shielding quasi-static magnetic fields. However, the need for space-saving solutions with high shielding performance requires the development of a three-dimensional (3D) modelling procedure capable of predicting the screening properties for different orientations of the applied field. In this paper, we use a 3D numerical model based on a vector potential formulation to investigate the shielding ability of SC screens with cylindrical symmetry and a height/diameter aspect ratio close to unity, without and with the superimposition of a ferromagnetic (FM) circular shell. The chosen materials were MgB2 and soft iron. First, the outcomes of the calculations were compared with the experimental data obtained with different shielding arrangements, achieving a notable agreement in both axial field (AF) and transverse field (TF) orientations. Then, we used this validated modelling approach to investigate how the magnetic mitigation properties of a cup-shaped SC bulk can be improved by the superimposition of a coaxial FM cup. Calculations highlighted that the FM addition is very efficient in enhancing the shielding factors (SFs) in the TF orientation. Assuming a working temperature of 30 K and using a layout with the FM cup protruding over the SC one, SFs up to eight times greater than those with a single SC cup were attained at applied field up to 0.15 T, reaching values equal to or higher than 10(2) in the inner half of the shield. In the AF orientation, the addition of the same FM cup incurs a modest worsening at low fields, but at the same time it widens the applied field range where SF > 10(4) occurs near the close extremity of the shield to over 1 T.

The current study aims to present and discuss the results obtained by complementary archaeometric methods applied for the first time on white pigments inlaid on excised pottery of the Boian-Vidra tradition (Early Chalcolithic, c. 4900-4600 BCE). The samples came from three settlements located in Southern Romania (Sultana-Ghetarie, Vidra, and Vladiceasca). They were selected considering that the pottery was produced in approximately contemporary sites, located relatively close to each other in the same geographical region, namely the Romanian Plain. The experimental part included the analysis of local samples of carbonate concretions and prehistoric animal bone ash as reference materials. Archaeometric investigations consisted in applying "in-air" PIXE and EDX methods for the chemical composition, XRD and FTIR for mineralogical data, SEM for microstructure observation, and EPR for the characterisation of the paramagnetic centres. Calcite, bone ash, and silica rich sediments were identified as the primary decorating pigments. The mixtures of calcite and bone-ash observed in 13 samples were specific to the sites at Vidra and Vladiceasca. Silica-rich sediments from distant sources were the main whitening materials in two samples from Vladiceasca, while for the samples from Sultana-Ghetarie, calcite was the only whitening mineral. The results show with a high degree of confidence the use of both local (i.e., carbonate neo-formations and bone ash) and exotic (silica-rich sediments) raw materials to obtain the white pigment applied to Boian-Vidra pottery. Thus, the current data show the adaptability of the potters with respect to the surrounding resources and also provide new evidence for a vast trade network of raw materials and/or finished products in the Lower Danube area during the Early Chalcolithic. The deliberate mixing of two whitening materials from different sources could be a technological choice and may highlight complex symbolic behaviours.

The deposition of a ferromagnetic layer can affect the properties of high-temperature superconductors underneath. We investigated the influence of ferromagnetic CaRuO3 on the properties of YBa2Cu3O7-x (YBCO) superconducting thin films when the layers are either in direct contact or separated by a barrier layer of 5 nm SrTiO3. Detailed measurements of the magnetic moment of the superconductor and ferromagnet as a function of temperature and magnetic field have been performed using SQUID magnetometry. Magnetometry and relaxation measurements show that the modification of the superconducting properties of YBCO strongly depends on the interaction with the ferromagnetic layer on top. The barrier layer has a significant impact on both the supercon-ducting properties of the YBCO film and the ferromagnetic ordering of CaRuO3. The physical properties mentioned above were discussed in correlation with the materials' structure determined by XRD analysis.

In this work, the influence of the preparation route on the structural, morphological, and thermoelectric properties of the Mg2Si0.4Sn0.6 solid solutions is investigated. The synthesis based on melting the constituent elements in a closed graphite crucible followed by spark plasma sintering allows mixing elements with a large difference of their melting temperatures and a good control of sample stoichiometry. The optimized synthesis route is validated by the doped V and Sb samples, which yield good thermoelectric performance. The n-type doping leads to two orders of magnitude increase of the carrier concentration, and thus a subsequent increase of the electrical conductivity, which, in turn, augments greatly the power factor of the Mg1.98V0.02Si0.385Sn0.6Sb0.015 to 42.61 x10(-4) Wm(-1)K 2 at 650K. Although doping slightly enlarges the thermal conductivity, a peak value of the figure of merit ZT similar to 1.15 is obtained at 723K, which is 20 times higher than the ZT of un-doped material.

A novel nanostructured platform for pyruvate oxidase biosensors comprises poly(neutral red) (PNR) prepared by electropolymerization of NR in ethaline deep eutectic solvent (DES) with acid dopant, on a multiwalled carbon nanotubes (MWCNT) modified glassy carbon electrode (GCE). Characterization was by cyclic voltammetry and electrochemical impedance spectroscopy and morphology was examined by scanning electron microscopy. Ascorbate and H2O2 gave a better response at PNRDES/GCE than at PNRaq/GCE. Biosensors for pyruvate and phosphate, immobilizing pyruvate oxidase onto PNRDES/MWCNT/GCE enabled selective determination of pyruvate and phosphate, with micromolar limits of detection. Pyruvate was determined in onion samples and phosphate in water samples.

This paper reports the synthesis and characterization of Cu2ZnSnS4 (CZTS) absorber films, prepared by a two-step electrodeposition of a ZnS (zinc sulfide) binary and a CZT (copper, zinc and tin) ternary precursors on Mo/Ti/Si substrates. The as-electrodeposited ZnS/CZT and CZT/ZnS stacks were thermally treated in a tubular furnace in sulfur environment at 550 degrees C. The role of the ZnS buffer layer is to provide a zinc and sulfur reservoir, needed to complete the formation of kesterite phase. X-ray diffraction and Raman analyses revealed the formation of the CZTS phase. The surface morphology and chemical composition of the films were studied using a scanning electron microscope. The bandgap values inferred from diffuse reflectance data, are discussed with respect to the stoichiometry which is considerably affected by the order of the stacks. Room-temperature photoluminescence of the CZT/ZnS sample showed a board PL band of 1.51 eV. It was found that the film with a ZnS layer on top is preferred for the formation of a Zn-rich single CZTS phase.