Publications

Simple Fe-Co ferromagnetic films and Fe-Mn antiferromagnetic films of different compositions were grown on epitaxial Si substrates with Ta buffer layers via thermo-ionic vacuum arc method. Fe-Co/Fe-Mn bilayer structures were obtained by following similar growing conditions as for the simple films. The magnetic behavior concerning easy axis distribution, anisotropy energy and coercive field of the Fe-Co films exchange coupled to the antiferromagnetic layers were discussed with respect to the magnetic behavior of the simple, uncoupled, ferromagnetic films. The composition of the antiferromagnetic films has a sensible influence on the magnetic parameters of the exchange coupled ferromagnetic films. The largest coupling and the narrowest easy axis distribution are induced in the bilayer system with equatomic composition of the Fe-Mn antiferromagnetic layer. (C) 2010 Elsevier B.V. All rights reserved.

We report on pulsed laser deposition of TiO2 films on glass substrates in oxygen, methane, nitrogen and mixture of oxygen and nitrogen atmosphere. The nitrogen incorporation into TiO2 lattice was successfully achieved, as demonstrated by optical absorption and XPS measurements. The absorption edge of the N-doped TiO2 films was red-shifted up to similar to 480 nm from 360 nm in case of undoped ones. The photocatalytic activity of TiO2 films was investigated during toxic Cr(VI) ions photoreduction to Cr(III) state in aqueous media under irradiation with visible and UV light. Under visible light irradiation, TiO2 films deposited in nitrogen atmosphere showed the highest photocatalytic activity, whereas by UV light exposure the best results were obtained for the TiO2 structures deposited in pure methane and oxygen atmosphere. (C) 2009 Elsevier B.V. All rights reserved.

Aluminum doped Zinc Oxide (AZO) and Lithium doped Zinc Oxide (LZO) thin films are obtained by Pulsed Laser Deposition (PLD) method. These films are characterized by using Spectroscopic Ellipsometry (SE), X-ray Diffraction (XRD) and Photoluminescence (PL). By modeling the ellipsometry spectra we get the dielectric functions, the optical band gap E(g), and the electrical properties. Our results show the influence of the processing parameters on the optical and structural properties of doped ZnO thin films. The post-annealing treatment applied to AZO thin films, changes strongly the optical properties, by lowering the resistivity and red-shifting the band gap. (C) 2009 Elsevier B.V. All rights reserved.

Two series of cobalt substituted Ni-Fe-Ga ferromagnetic shape memory alloys with lower gallium content (< 27 at. %) were studied by differential scanning calorimetry, x-ray diffraction, and thermomagnetic measurements. Co substitution for Fe or Ni promotes an increase in the Curie temperatures and a variation in the martensitic transformation (MT) temperatures, in accord with the alloy valence electron concentration change. For alloys with MTs below room temperature, a field dependent thermomagnetic hysteresis was evidenced and discussed in connection with the effect of cobalt substitution, on the magnetic hardness of the martensite phase. A direct interpretation of the evolution of the thermomagnetic hysteresis versus the applied field was provided. (C) 2010 American Institute of Physics. [doi: 10.1063/1.3429231]

The short-circuit photocurrent was measured in ferroelectric capacitors of polycrystalline and epitaxial quality. The interest was to study the possible relation between photocurrent and back-switching phenomena due to ferroelectric polarization imprint, as suggested by Pintilie [J. Appl. Phys. 101, 064109 (2007)]. An interesting relation between the shape of the ferroelectric hysteresis loop and the shape of the photocurrent spectral distribution was found. In polycrystalline samples, the shape of spectral distribution and the sign of photocurrent are changing in time, although the hysteresis is almost symmetrical. However, the hysteresis is not rectangular as in the case of epitaxial films. This behavior suggests a subtle relation between polarization back-switching and photocurrent. In epitaxial samples a peculiar dependence between photocurrent and polarization imprint was found. All these are explained assuming the presence of an internal field, possibly generated by charged defects, which can change its direction and magnitude under illumination, with consequence on the orientation and magnitude of the ferroelectric polarization, and on the sign/shape of the short-circuit photocurrent spectral distribution. (C) 2010 American Institute of Physics. [doi: 10.1063/1.3445877]

The implants surfaces investigated in the present study were modified with the films of poly (vinyl) alcohol (PVA) which were formed in physiological serum (0.9% NaCl). Surfaces evaluation included electrochemical measurements such as linear potentiometry (LP) and electrochemical impedance spectroscopy (EIS). These suggest that PVA acts by adsorption at site on the metal surface and formed a compact, adherent and uniform layer. The composition of layer was estimated using Scanning Electron Microscopy with Energy Dispersive X-ray Spectroscopy (SEM/ EDX) and X-ray Photoelectron Spectroscopy (XPS) techniques, which confirm the adsorption of PVA on the surfaces, through -OH groups, with a specific affinity to the titanium sub-strate.

We report here on the nitrogen doped ZnO (ZnO:N) thin films deposited by radio frequency (rf) magnetron sputtering using ZnN target (99.9% purity) on, unintentionally heated, fused silica substrates. After deposition Rapid Thermal Annealing (RTA) at 400 and 550 degrees C for 1min in N-2 ambient have been performed on the ZnO:N thin films. The RTA impact on the optical and microstructural properties of ZnO:N thin films have been investigated by X-ray diffraction, Atomic Force Microscopy, Scanning and Transmission Electron Microscopy coupled with Energy Dispersive X-ray analysis, UV-VIS-NIR spectrophotonnetry and UV-VIS-NIR-Far IR Spectroscopic Ellipsometry. XRD and AFM results revealed an improvement in the crystalline state of ZnO:N and a reduction in the films surface roughness following RTA. The EDX spectrum showed the presence of the nitrogen in small quantities in the ZnO structure (nitrogen/oxygen=1/8). The optical constants of ZnO:N from UV down to Far IR spectral range together with the infrared active modes for ZnO:N are also reported.

Exchange bias AF/Fe and spin valve AF/Fe/Cu/Fe (AF=Fe50Mn50 and Ir50Mn50) multilayer systems have been prepared by molecular beam epitaxy. Thin tracer layers enriched in the Fe-57 isotope were artificially grown at the AF/Fe interface and the phase composition of the ferromagnetic layer, as well as the interfacial atomic diffusion were observed via Fe-57 conversion electron Mossbauer spectroscopy. The dependence of the magnetization reversal process on training and temperature associated effects was studied by low temperature vibrating sample magnetometry, whereas the interlayer magnetic coupling was analyzed via longitudinal magneto-optic Kerr effect.

In order to study the influence of the cations substitution on permeability of cobalt ferrites four series of samples with different chemical composition were prepared by conventional ceramic method. The calcined powders and sintered samples were characterized by X-ray diffraction and vibrating samples magnetometer. The microstructure of the samples was analyzed by surface electron microscopy. The initial permeability spectra at room temperature were plotted using the torus standard method. Chemical composition and the microstructure influence the magnetic properties and the initial permeability spectra of the cobalt ferrites samples. Small amount of manganese ions decreases the Curie temperature, increase the initial permeability and saturation magnetization and decreases the coercive magnetic field, thus improving the performances of cobalt ferrites for magnetostrictive sensors applications.

Holmium-doped BaTiO3 with composition Ba0.97Ho0.03TiO3 was prepared by sol-gel combustion method. A molar ratio of citrate/nitrate (CA/NO3- = 1.3) was used to prepare nanopowders of (Ba,Ho)TiO3. The structure and microstructure of (Ba,Ho)TiO3 powders and ceramics were investigated. The ceramics exhibit a dielectric constant of about 4400 and dielectric loss (tan delta = 0.267) at 10 Hz, and at the Curie temperature (T-c = 132 degrees C). The remanent polarization and the coercive field of Ba0.97Ho0.03TiO3 ceramics, at 1 kHz, were P-r = 6 mu C/cm(2) and E-C = 0.75 kV/cm. The dielectric and ferroelectric behavior of the holmium-doped BaTiO3 is influenced by the amphoteric character of Ho3+ ions.