National Institute Of Materials Physics - Romania

This paper relates to a method for the preparation of lead acetate film and its use as precursor for twostep solution deposition of CH3NH3PbI3 perovskite film. For the preparation of perovskite film, lead acetate was used both in the form of trihydrate and dehydrated. The effects of lead acetate trihydrate dehydration on the structure of the resulted perovskite films were studied. The prepared perovskite films which consist of cuboid grains, show high surface coverage both on FTO and TiO2 substrates. XRD measurements have not revealed the presence of the PbI2 contaminant in perovskite film. Solvent vapor annealing method was employed to prepare perovskite film that contains lead iodide. Using impedance spectroscopy measurements, we further evaluated the influence of the prepared perovskite films on the performance of the photovoltaic devices. (C) 2017 Elsevier Ltd. All rights reserved.

Hierarchical flowers-like zinc oxide structures have been successfully obtained by a simple and fast ultrasound-assisted method performed in a ordinary ultrasonic bath using an ammonia solution and zinc acetate, in the absence of any surfactant or template. The composition, structure, crystallinity, morphology and optical properties of the materials obtained at different ultrasound irradiation times were characterized by infrared, UV-Vis and photoluminescence spectroscopy, X-ray diffraction, scanning and transmission electron microscopy investigations. It was proved that the ultrasound irradiation time manipulates both the defect content (implicit the photoluminescent properties) and morphology of the ZnO materials: shorter irradiation times leads to the synthesis of high-defected ZnO structures of flower morphology with triangular-shaped petals, while higher irradiation times favours the formation of low-defected ZnO structures with tipped rod-like petals. A plausible growth mechanism of the architectures that implies aggregation via oriented attachment followed by an Ostwald ripening is advanced based on these results. The ZnO flower-like structures present high photocatalytic activities, a total phenol mineralization being registered in the case of visible light experiments. Electron-spin resonance measurements demonstrate the generation of reactive oxygen species, namely hydroxyl radicals but also C centred radicals adducts derived most probable from the residual acetate adsorbed on ZnO surface. (C) 2016 Elsevier B.V. All rights reserved.

Multifunctional Fe3O4@Nb2O5@Co@Re catalysts with metal loadings in the range of 2-7 wt % were prepared via a multistep process. Magnetic nanoparticles prepared by coprecipitation were covered with a niobia shell precipitated from an ammonium niobate oxalate complex in the presence of hexadecyltrimethylammonium bromide. The deposition of cobalt was performed using a deposition/precipitation procedure. Finally, rhenium has been deposited following three different routes: (i) impregnation, (ii) deposition and precipitation of rhenium chloride (ImC and PP, respectively), and (iii) impregnation with ammonium perrhenate (ImA). The characterization of these catalysts was achieved by X-ray diffraction, Raman, H-2 and NH3 temperature-programmed desorption, X-ray photoelectron spectroscopy, and transmission electron microscopy showing the influence of the preparation procedure, reduction, and Re/Co cooperation on the degree of dispersion and reduction. ImC and ImA routes led to more reduced catalysts, and the decrease in cobalt content corresponded to more reduced rhenium. An inverse relation between the acidity and the degree of reduction has been found. The screening of these catalysts in the fragmentation of the lignin confirmed the role of the structural characteristics and solvent. ImC catalysts exhibited better catalytic activity, especially for low metal loadings [2%Co@3%Re, 85% yield of LF, 15.5% yield of LR in tetrahydrofuran (THF), and 14.5% yield of insoluble LR in THF]. Although the extent was smaller, the PP catalysts allowed a more advanced fragmentation of the lignin to fragments with molecular weights between 200 and 400 Da. The catalysts were totally recovered by application of a magnetic field and recycled six times without any loss of activity or selectivity.

Two series of cyclometalated palladium(II) complexes based on Schiff bases and N-benzoylthiourea (BTU) ligands having four alkoxy groups at their periphery, with different number of carbon atoms, have been designed and prepared. The liquid crystalline behavior of these palladium(II) complexes was investigated by a combination of polarized optical microscopy (POM), differential scanning calorimetry (DSC) and powder X-ray diffraction while their thermal stability was studied by thermogravimetric analysis (TGA). The palladium(II) complexes are thermally stable on a broad temperature range up to 230 degrees C showing, depending on the alkoxy chain length, either monotropic or, for longest alkyl chain, enantiotropic smectic A and C phases. The luminescent properties of palladium(II) complexes were reported. These complexes show a yellow-orange solid-state emission at room temperature with two emission maxima at lambda(max) around 580 and 650 nm, respectively, with a shoulder around 710 nm, when the samples are irradiated in the 330-380 nm range. (C) 2017 Elsevier B.V. All rights reserved.

Reduced-activation steels such as Eurofer alloys are candidates for supporting plasma facing components into kamak-like nuclear fusion reactors. In order to investigate the impact of hydrogen/deuterium insertion in their crystalline lattice, annealing treatments in hydrogen atmosphere have been applied on Eurofer slabs. The resulting samples have been analyzed with respect to local structure and atomic configuration both before and after successive annealing treatments, by X-ray diffractometry (XRD), scanning electron microscopy and energy dispersive spectroscopy (SEM-EDS), X-ray photoelectron spectroscopy (XPS) and conversion electron Mossbauer spectroscopy (CEMS). The corroborated data point out for a bcc type structure of the non-hydrogenated alloy, with an average alloy composition approaching Fe0.9Cr0.1 along a depth of about 100 nm. EDS elemental maps do not indicate surface inhomogeneities in concentration whereas the Mossbauer spectra prove significant deviations from a homogeneous alloying. The hydrogenation increases the expulsion of the Cr atoms toward the surface layer and decreases their oxidation, with considerable influence on the surface properties of the steel. The hydrogenation treatment is therefore proposed as a potential alternative for a convenient engineering of the surface of different Fe-Cr based alloys.(C) 2017 Elsevier B.V. All rights reserved.

High performance trilayer memory capacitors with a floating gate of a single layer of Ge quantum dots (QDs) in HfO2 were fabricated using magnetron sputtering followed by rapid thermal annealing (RTA). The layer sequence of the capacitors is gate HfO2/floating gate of single layer of Ge QDs in HfO2/tunnel HfO2/p-Si wafers. Both Ge and HfO2 are nanostructured by RTA at moderate temperatures of 600-700 degrees C. By nanostructuring at 600 degrees C, the formation of a single layer of well separated Ge QDs with diameters of 2-3 nm at a density of 4-5 x 1015 m(-2) is achieved in the floating gate (intermediate layer). The Ge QDs inside the intermediate layer are arranged in a single layer and are separated from each other by HfO2 nanocrystals (NCs) about 8 nm in diameter with a tetragonal/orthorhombic structure. The Ge QDs in the single layer are located at the crossing of the HfO2 NCs boundaries. In the intermediate layer, besides Ge QDs, a part of the Ge atoms is segregated by RTA at the HfO2 NCs boundaries, while another part of the Ge atoms is present inside the HfO2 lattice stabilizing the tetragonal/orthorhombic structure. The fabricated capacitors show a memory window of 3.8. +/-. 0.5 V and a capacitance-time characteristic with 14% capacitance decay in the first 3000-4000 s followed by a very slow capacitance decrease extrapolated to 50% after 10 years. This high performance is mainly due to the floating gate of a single layer of well separated Ge QDs in HfO2, distanced from the Si substrate by the tunnel oxide layer with a precise thickness.

The electronic structure of alpha-Sn (001) thin films strained compressively in-plane was studied both experimentally and theoretically. A new topological surface state (TSS) located entirely within the gapless projected bulk bands is revealed by ab initio-based tight-binding calculations as well as directly accessed by soft x-ray angle-resolved photoemission. The topological character of this state, which is a surface resonance, is confirmed by unravelling the band inversion and by calculating the topological invariants. In agreement with experiment, electronic structure calculations show the maximum density of states in the subsurface region, while the already established TSS near the Fermi level is strongly localized at the surface. Such varied behavior is explained by the differences in orbital composition between the specific TSS and its associated bulk states, i.e., their hybridization, respectively.

TiO2 nanoparticles, undoped and doped with Fe, have been prepared by laser pyrolysis and further investigated with respect to morphological, structural and magnetic aspects by transmission electron microscopy, diffractometry, Mossbauer spectroscopy, and magnetometry. The obtained nanoparticles, consisting of mainly anatase phase, agglomerate in clusters of tenths of units and present a large size distribution in the range from 5 to 40 nm. The anatase to rutile weight ratio (about 9) and the morphology of particles is similar in all analyzed samples (doped by up to 12 0,0 at. % Fe). Only Fe3+ ions in high spin-configuration were observed mainly at the, surface of TiO2 nanoparticles, either distributed or forming fine clusters of Fe oxide.;:Both a paramagnetic phase and a superparamagnetic one with blocking temperature lower than 50 K are superposed over a long-range ferromagnetic phase specific to diluted magnetic oxide systems. The influence of doping Fe ions on the magnetic behavior of each phase is discussed in detail. Evidences for interface exchange couplings (with unidirectional anisotropy in specific conditions) between the long-range ferromagnetic phase and the fine clusters (antiferromagnetic in nature), which become frozen below temperature of 50, K, are provided. The specificity of the processing route and the physical mechanisms responsible observed relevant magnetic features, which can be tailored for suitable applications, are discussed.

N-Containing graphenes obtained either by simultaneous amination and reduction of graphene oxide or by pyrolysis of chitosan under an inert atmosphere have been found to act as catalysts for the selective wet oxidation of glucose to succinic acid. Selectivity values over 60% at complete glucose conversion have been achieved by performing the reaction at 160 degrees C and 18 atm O-2 pressure for 20 h. This activity has been attributed to graphenic-type N atoms on graphene. The active N-containing graphene catalysts were used four times without observing a decrease in conversion and selectivity of the process. A mechanism having tartaric and fumaric acids as key intermediates is proposed.

The purpose of this study was to obtain, characterize and evaluate the cytotoxicity and antimicrobial activity of coatings based on poly(3-hydroxybutyric acid-co-3-hydroxyvaleric acid) -Lysozyme (P(3HB3HV)/ Lys) and P(3HB-3HV) -Polyethylene glycol -Lysozyme (P(3HB-3HV)/PEG/Lys) spheres prepared by Matrix Assisted Pulsed Laser Evaporation (MAPLE) technique, in order to obtain functional and improved Ti-based implants. Morphological investigation of the coatings by Infrared Microscopy (IRM) and SEM revealed that the average diameter of P(3HB-3HV)/Lys spheres is around 2 mm and unlike the drop cast samples, IRM recorded on MAPLE films revealed a good distribution of monitored functional groups on the entire scanned surface. The biological evaluation of MAPLE structured surfaces revealed an improved biocompatibility with respect to osteoblasts and endothelial cells as compared with Ti substrates and an enhanced anti-biofilm effect against Gram positive (Staphylococcus aureus) and Gram negative (Pseudomonas aeruginosa) tested strains. Thus, we propose that the fabricated P(3HB-3HV)/PEG/Lys and P(3HB-3HV)/Lys microspheres may be efficiently used as a matrix for controlled local drug delivery, with practical applications in developing improved medical surfaces for the reduction of implant-associated infections. (C) 2017 Elsevier B. V. All rights reserved.