Publications

The compositions in the ternary chalcogenide systems from the demarcation region between the glass-formation domain (GFD) and the partially or fully crystalline formation domain seem to exhibit outstanding properties. We have shown in this paper that the compositions with the best memory-switching properties are situated at the border of the GFD in many systems. One can use this correlation to find new phase-change materials with better switching properties or to discover GFDs that were not observed yet. (C) 2013 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

GeSi nanostructured films were obtained by cosputtering from two Ge and Si targets and subsequent annealing in furnace in N-2 for 5 h at 700, 800 and 900 degrees C, with the aim to show the correlation between electrical properties and crystalline structure of the films. The as-deposited films are amorphous, have a Ge: Si composition of 55: 45 and 185 nm thickness. The film structure was investigated by XRD and TEM, and the electrical behaviour was studied by measuring current-voltage (I-V) and current-temperature (I-T) characteristics and by discussing them in correlation with the structure. Different electrical behaviours of GeSi films corresponding to different structures have been evidenced. The 700 degrees C annealed GeSi films are formed of nanocrystals (7-15 nm) separated by amorphous regions (1-2 nm). These films present a superlinear I-V characteristic typical of high field-assisted tunnelling through potential barriers (amorphous regions) between nanocrystals. The I-T characteristic at low temperature follows a T-1/2 law showing a thermally activated tunnelling of carriers between neighboring GeSi nanocrystals. The films annealed at 800 and 900 degrees C have a like behavior, they are completely crystallized and present linear I-V and Arrhenius I-T dependences reflecting the polycrystalline behaviour. [GRAPHICS] . (C) 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

The complex chalcogenides with excellent memory switching properties are mainly situated close to the border of glass formation domain. The simulation of the structural changes occurring during the memory switching process of a ternary chalcogenide composition has been carried out. The transition of a high resistivity GeAs4Te7 amorphous cluster with 120 atoms to a low resistivity crystalline cluster was analyzed. The coordination of atoms changes from that corresponding to 8-N coordination rule (two for tellurium, three for arsenic, and four for germanium) in the amorphous phase to six (the same for all atoms) in metastable crystalline phase. Because of spatial constraints exercised by the amorphous matrix, the amorphous cluster cannot expand. In these circumstances Te atoms seem to be over-coordinated (up to sixfold-coordinated). During the switching process, the atoms are moving on distances up to 4.0 angstrom. The average displacement is of 2.36 angstrom.

Micropatterned ZnO was synthesized by an electroless deposition process using Au stripes as catalytic surfaces. The Au-patterned electrodes were prepared on SiO2/Si wafers using photolithography. The site-selective deposition of patterned ZnO hexagonal rod arrays is confirmed by scanning electron microscopy. The ZnO micropatterned surface revealed a conversion of wettability from hydrophilic to super-hydrophobic depending on the deposition reaction parameters. The electrical measurements carried out at room temperature before and after exposure to ammonia vapors of the patterned ZnO arrays show a resistance variation with exposure time. Highly reproducible, easy scalable and low-cost, photolithography and electroless deposition techniques could provide a facile approach to fabricate functionalized micropatterns, for a wide range of applications. (C) 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

First principles FPLAPW calculations were performed in the framework of Density Functional Theory (DFT), to study the electronic structures and magnetic properties for the new full-Heusler compounds: Sc(2)CoZ (Z = Si, Ge, Sn). The investigated materials are stable against decomposition, in ferromagnetic configuration and crystallize in the inverse Heusler structures. The half-metallic properties as function of the variation of unit cell volumes are analysed regarding the fourth main group constituent elements. The electronic structure calculations for Sc2CoSi and Sc2CoSn show half-metallic characters, with indirect band gaps of 0.544 eV and 0.408 eV at optimised lattice parameters of 6.28 angstrom and 6.62 angstrom, respectively. For Sc2CoGe compound, the Fermi energy is not pinned inside the energy band gap from minority density of states, neither for unit cell contraction nor for enlargement. The calculated total magnetic moments are 1 mu B/f.u., for all compounds, in agreement with Slater-Pauling rule. (C) 2014 Elsevier B. V. All rights reserved.

We study the effects of intraband relaxation processes on optical manipulation protocols for sp biexcitons hosted by CdTe disk-shaped quantum dots. The many-body states are calculated within the configuration interaction method starting from single-particle states given by the k.p theory. The time-dependent occupations of relevant many-body states are extracted from the von Neumann-Lindblad equation for the density operator. We mainly investigate the generation of sp biexcitons with two pulses of different polarizations sigma(+) and sigma(-). The fast hole relaxation processes prevent a high-fidelity controlled operation on sp biexcitons and lead to the occupation of some transient states which can be optically probed. More importantly, the many-body structure of the transient states consists of two holes on the s shell and antiparallel sp triplet states for electrons. Our simulations show that these triplet states are more stable against decoherence as they can only be damaged through slow electron relaxation. The configuration mixing due to correlation effects is also discussed.

Electrochemical impedance spectroscopy investigations carried out in solutions with different pH brought evidence that the monolayers of L-cysteine-thiolate self-assembled on GaAs (hid) electrodes exert a complex molecular control over their electrochemical behavior. The analysis of the impedance spectra coupled with that of the XPS data and the AFM images taken before and after the EIS measurements reveled that both pH and applied potential brings significant changes at the electrified interface. The most important effect of pH is the conformational change of the L-cysteine-thiolate molecule observed at pH 11 that allows the interaction of the carboxyl group with the substrate atoms. A similar conformational change occurs at pH 5.5 but only under the applied potential control, being just a consequence of another major effect of the applied electric field. This is the H+ transfer inside the L-cysteine-thiolate film, an electric field driven process but pH dependent, which results in significant charge diminution both in the organic overlayer and in the semiconductor depletion region. (C) 2013 Elsevier Ltd. All rights reserved.

The energy band alignment at interfaces between different materials is a key factor, which determines the function of electronic devices. While the energy band alignment of conventional semiconductors is quite well understood, systematic experimental studies on oxides are still missing. This work presents an extensive study on the intrinsic energy band alignment of a wide range of functional oxides using photoelectron spectroscopy with in-situ sample preparation. The studied materials have particular technological importance in diverse fields as solar cells, piezotronics, multiferroics, photoelectrochemistry and oxide electronics. Particular efforts have been made to verify the validity of transitivity, in order to confirm the intrinsic nature of the obtained band alignment and to understand the underlying principles. Valence band offsets up to 1.6 eV are observed. The large variation of valence band maximum energy can be explained by the different orbital contributions to the density of states in the valence band. The framework provided by this work enables the general understanding and prediction of energy band alignment at oxide interfaces, and furthermore the tailoring of energy level matching for charge transfer in functional oxides. (C) 2014 WILEY-VCH Verlag GmbH & Co. KGaA, Weinheim

We report on the changes on the microstructural, hardness, and corrosion properties induced by carbo-chromization of 316L stainless steel prepared by Spark Plasma Sintering technique. The thermo-chemical treatments have been performed using pack cementation. The carburizing and chromization were carried out between 1153 K (880 A degrees C)/4 h to 1253 K (980 A degrees C)/12 h and 1223 K (950 A degrees C)/6 h to 1273 K (1000 A degrees C)/12 h in a solid powder mixture of charcoal/BaCO3 and ferrochromium/alumina/NH4Cl, respectively. The obtained layers were investigated using X-ray and electron diffraction, optical and scanning electron microscopies, Vickers micro-hardness, and potentiodynamic measurements. The thickness of the carbo-chromized layer ranges between 300 and 500 mu m. Besides the host gamma-phase, the layers are mainly constituted of carbides (Fe7C3, Cr23C6, Cr7C3, and Fe3C) and traces of alpha'-martensite. The average hardness values decrease smoothly from 650 HV at the sample surface down to 200 HV at the center of the sample. The potentiodynamic tests revealed that the carbo-chromized samples have smaller corrosion resistance with respect to the untreated material. For strong chromization regimes, the corrosion rate is increased by a factor of four with respect to that of the untreated material, while the micro-hardness of the layer is three times larger. Such materials are suited to be used in environments where good corrosion resistance and wear properties are required.